Ongoing‎ > ‎

Tuning the finger board

posted 26 Jun 2014, 11:27 by Peter Grankulla
Tuning the finger board and thereby setting B0 at the desired level (270 Hz) can be quite a difficult task. This time I glued the roughly made FB and adjusted all the neck/FB dimensions right. The tuning procedure was then easier:

1. Measured the B0 frequency and calculated new FB frequency (425 Hz). 
2. Unglued the FB and tuned it to 422 Hz and 65 g

I have a little margin to tune B0 up or down a few Hz once the FB has been permanently glued to the neck.

 


Comments